My gasket was in the shape as shown.
I got that gasket paper on and pushed it down around the edges to get the shape of the gasket. then I used the ball bit of a ball-pien hammer to lightly tap the edges to reveal the gasket lining.
Got the outer lining done and the holes for the screws punched out. Then on with the inner bit.
Got the inner part punched out and the gasket is made! Now let’s fit this thingy back to the engine.
So far so good…
Yes! The gasket works!
Awesome! If you look closely between the engine head block and water circulation joint. We have a gasket!
No comments:
Post a Comment